Woodslasher's latest activity
-
Got an evacuation notice close to me, figured out I knew the guy, talked to some ex co workers about it and found out my one foreman has... -
Modified Mark provided me with the details on the seals (I had the right parts on hand), and Bufford Parrish had rings, the AF cover...
-
Woodslasher reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Ed - your PM55 has points ignition, make sure any crankshaft you get has the points cam/lobe. All of the 54, 57, 60, and 71cc 10 Series... -
Woodslasher reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Scott, I would normally start with 1-1/14 turns open on both H &L. The fact that it starts with throttle and no choke would indicate...
-
Woodslasher reacted to Scott Kelsey's post in the thread MCCULLOCH The official McCulloch thread with Like.
Hoping someone here will help me out as I did some searching, but can not find what I am looking for. I recently purchased this Pro Mac...
-
-
Late September in the Mitten??? Pfffft. You’d freeze
-
If i remeber correctly the XR had a adjustable carb needle and XL did not,, we put XR needles in the XL and moved the needle up,,, bike...
-
Woodslasher reacted to jacktheripper's post in the thread Foam filter? Or leave it with the stock filter? MMWSms462 with Like.
And an 044? 😁 I snagged a Maxflow foam filter kit to throw on my 044 that Randy is doing. I run a Maxflow on my 440/460, and on my 064...
-
Weatherman was 26 hours too soon with his rain prediction so I was 26 hours and 1 minute early getting the paper on.
-
Shiny new 28” Bar and compliments of @Jusgunn3 a new RSK chain. Should cut well if I didn't put it on backwards.
-
Careful Bob, old bones don't heal as quickly as they used to... Mark
-
Net pic but same bike,, needs a little TLC,, been sitting for 4 years, bike has been in one family all its life,, I rode the same bike...
-
Woodslasher reacted to redneckhillbilly's post in the thread Opening an Independent Saw Shop with Like.
i think in order to get dealership pricing you have to become a dealer, that means buying and trying to sell dealer brand bar oils for...
-
Woodslasher reacted to dangerousatom's post in the thread Opening an Independent Saw Shop with Like.
IMO start in your garage and work on friends & neighbors stuff. If your good at what you do and everyone is fine with your pricing and...
