Woodslasher's latest activity
-
Woodslasher replied to the thread The giveaway thread 20/21/22/23/24/25.Free stuffs, HT73 ran until the nla tube shaft busted, it got a new p/c, coil, and crank a few years back so the guts should still be... -
-
Adapter fitting just arrived
-
New feed line to regulator, New return line from regulator made and 1 end from regulator to rail done. Waiting on the 3/8" quick...
-
Keep it and make it pay for itself
-
I like how other countries put a health scale and their stuff with six ingredients but the US promotes food with an encyclopedia printed...
-
Fun fact: commercially produced food tends to contain vast quantities of carbon, hydrogen, and oxygen, which also is used in explosives...
-
So does your body and everybody's body
-
Woodslasher reacted to jacob j.'s post in the thread MCCULLOCH The official McCulloch thread with
Like.
I might have a chunk of that Mark - will look after the holidays. -
My caliper was hanging up and TSX brakes fit with a little cutting and bending. Got junkyard calipers and new pads and rotors. I’m about...
-
Got my new work bench installed today no more using the Jeep tailgate lol. This was part of the countertop when my dad first built his...
-
I had this happen to me. Totally full of tools. I was unloading it from a trailer by myself. No damage done.
-
You’re right about that. Hard to soft catch a 1000lb lathe. The only damage is where I had to jack on the pan to get it back up...
-
Not really. Oem rails have feed in middle of rail. On a return, feed and return on middle of left rail. I currently feed rear of left...
-
4 hours of messing with the fuel rails, brackets and o-rings and I can't get them to seal enough to trust it. I had one side sealed up...
-
