Recent content by WillG

MS361 reassembled and carb tweaked

Dad's buddy's MS361, fuel line replacement. What kinda grinds my gears is that the local hardware store/repair place charged him $80 to check it out and tell him nothing was wrong with it

Need IPL for an ms192T please

Lit up a Thermos lantern in his memory tonight. Lantern was made in Illinois where he was from

So sad. I didn't know him personally but he and I talked regularly. He seemed like a real stand up guy. Sending thoughts and prayers to his family. I'll light up a lantern in his memory tomorrow evening.

Unfortunately the idle circuit is non adjustable

Ryobi 1800 watt inverter generator was on the bench yesterday. Got a new carb. Was surging at idle and even cleaning the carb in the ultrasonic cleaner couldn't get the idle circuit clean. What a pain in the butt to work on!!

Husqvarna 150BT Replaced the carb with a new aftermarket one. Need to pick up a new plug and replace the fuel filter. Then a good test run and up for sale

Put the 125BT back together with a good used flywheel

Thanks guys I'll do 11 ft lbs

Looking for a workshop manual for a 125BT backpack blower. Need flywheel nut torque

Husqvarna 125BT backpack blower with a cracked flywheel. Fortunately the crank and key were okay. Another flywheel is on the way.

New addition arrived today. 1/76 Canadian 335. Oiled the pump cup, tightened the valve and tip cleaner packing nuts a little, tied on a new mantle and away she went. Sent from my E6910 using Tapatalk

Just got these 2 burning this evening. Both 200A single mantle. One is dated 7/1955 and the other is 6/1956. They both just needed the pump leather oiled, pulled the pump check valve on both out and cleaned them in the ultrasonic cleaner, replaced the fuel cap seals, cleaned/flushed the fuel...

Just got into collecting Coleman stoves and lanterns about a month ago. So far I'm at 7 lanterns from 1955-1970 and 3 stoves from 1966 to the early 70s. Pretty cool hobby. Sent from my E6910 using Tapatalk