Wilhelm's latest activity
-
I'm gonna suggest a vacuum\pressure test Tom. If this saw ain't got a strong impulse signal, it ain't gonna run. That divot at the port... -
I’ve had strange results lately with compression on both a 272 and an 064. Turned out with both of them that the ring gap was too big...
-
Wilhelm reacted to SOS Ridgerider's post in the thread Looking for 3/8”LP 7pin small spline rim sprocket with
Like.
Sending PM! -
I found the post. @Wilhelm It looks like this rim of theirs with the 3/8-7 marking is the LP version. Not surprisingly, the full 3/8...
-
Bosch are good if you get the German made , but China stuff not so good ,
-
Wilhelm replied to the thread Defective Champion Spark Plug.NGK for me, have yet to encounter one to fail on me. Champion, Bosch & off-brand plugs that come with saw purchases get replaced with...
-
Wilhelm replied to the thread Great Moments in Chainsaw Serendipity.This And then fine tune adding one of these at a time. Should make for a "spicy" saw!
-
-
1" pipe plugs if I remember correctly. Mark
-
I will definitely have have to give it a try...I don't need the originals, just need to keep the liquids from sloshing out!! Thanks!
-
Wilhelm replied to the thread Husqvarna SM Rim 3/8P.I have a large spline Archer (RatioParts) rim that was sold to me as full size 3/8" - but it doesn't fit more than two DL's properly...
-
i have used a standart 3/8 rim with 3/8 picco chain. after 10 minutes you can throw both in the garbage.
-
Wilhelm reacted to hacskaroly's post in the thread Funny pic's and gifs 2021/2022/2023/2024/2025 with
Haha.
Signs are usually created because someone has done something wrong... -
Philbert
-
Thanks.
-
Wilhelm reacted to Squish9's post in the thread The Small Dolmar/Makita Thread..Max 50cc class with Like.
It's just out here being helpful. Wish the oil fill hole was bigger to suit my combi can, other wise it's pretty awesome for a 34cc saw
