Wilhelm's latest activity
-
That stump was quite a bit of work… I’m sure glad it’s gone. -
DAMN
-
-
This tree fell during last week's storm. Went right between these two and didn't even break a limb off.
-
Im at home in the city,,,, heard the crows going nuts,, two great horned owls ,, one adult one large chick.
-
Great! Thanks!
-
That's the exciting part for me is having the ability to make tools that you need. Thanks again for all of the great info!
-
No worries, I grew up in Canada, so I can think in metric too. They were just switching over when I was a kid, so for some things I...
-
Wilhelm replied to the thread The Metalworking Thread.At one point we had no ER32 key at work, for a couple months, for 18 mills, hundreds of tool holders. I began making my own custom ones...
-
-
Wilhelm replied to the thread The Metalworking Thread.Don't forget to acquire fitting collet holder nut keys! It took my workplace over half a decade to buy keys for every collet holder...
-
@Squareground3691 and @Wilhelm, thanks so much for the help! I was leaning towards an ER32 holder and collet set, and it sounds like...
-
Wilhelm replied to the thread The Metalworking Thread.ER11 & ER16 collets clamp down by 1.0mm from specified clamping OD, though You should stay shy at no more than 0.9mm. ER32 collets will...
-
Yes , the collets will work for all ur diameter applications,
-
Also use ER 16 , for small diameter applications a lot ,
-
Wilhelm replied to the thread The Metalworking Thread.Also, out of ballance throw is lower with solid/Weldon holders. You may prefer them for milling. Though quality brand collets are...
