Recent content by TreeHunter

Hey Ray, I am looking for an IPL and service manual for a Husqvarna 346xp. Thanks in advance.

Hey Ray, I am looking for an IPL and service manual for a Husqvarna 350. Thanks in advance.

I am looking for a service manual and an ipl for a MS261c. Thanks in advance Ray!

Although, I suspect a motor control unit safety shutdown! I think this is it. I worked at a conveyor factory and they were working a new conveyor model with controls to provide amp load shut off feature for safety. Its the same thing they do in these electric saws since they found out they can...

So this was it, all part numbers match the model and the IPL. What they call the brake lever was bent, I did my best to get it closer but damn if its still not right. And yall probably know this part is robust, its like 1/4 plate formed steel or some *s-word, so this saw must have had a serious...

You're right! I will check for part numbers. With your pictures below and the other input here I think we've got this thing licked!

Thank you Stump Shot, This confirms it for me.

No hole for decomp. TY

Hey guys, I have this 372XP here, OE non X torq model. The reason I say that is I believe someone before my time with it put an Xtorq flag here and it is striking the top cover. It could be the other way around but in my coarse research, this is what I think has happened. The original unit has a...

I have run Worky-quad's, multi-1's, Avant and the Giant loaders and the Giant is far and above the best. The avant is nice and comfy but visibility is an issue and the whole thing is shrouded in thin hard plastic that just simply has no pushback and it doesnt last. The units seem big for their...

Greetings Mr Benson, I am looking for manuals for a MS150tc and also for a MS241c. Thanks in advance

Theyre not going to be gettin their work done then.....

I also have only 3 (running/operational) saws in my 3 saw plan. All Huskies; a T525, a 450E and an older rebuilt 372XP. Also have a problematic nonrunning 540xp mark I and a nice Stihl150t in need of a clutch cover assy. Soo..... that's 5 saws, in other words 3 saws for yer 3 saw plan.

I hadn't thought about this but yes, absolutely. There are no adjustment screws on this thing. Thinking more about this and considering what Stump Shot said first, I feel like there is an air leak somewhere and I have to track it down.

I have a Mark 1 T540xp. The saw was originally shelved dirty ad with gas in the tank roughly 5 years ago. The coil was tight against the flywheel. Perhaps the original reason for being shelved in combination with the hot starting issues this saw is known for? Anyway, I corrected the ignition...