Tor R's latest activity
-
Send Cuban Cigars. Thanks -
Damn! Yeah, it’s best to upgrade. If you get an efficient enough unit it’ll pay for itself with electric savings. Try to switch to...
-
Tor R reacted to Only the Tony's post in the thread Not so pros 4 new and without politics with
Like.
Just "borrow" some equipment from work and convert it to r1234yf. If it dies then no harm since you are replacing it anyway. If you... -
50 cad so $36 usd
-
I have the Carlton version of the 511A, I was not too happy with the results using the pink vitrified wheels but once I spent the $$ and...
-
used,,,I can see if i like this,,, have always hand filed.
-
No need to tear it all the way down for that area, it's far away from any gaskets and seals that could be damaged from heat. Leave the...
-
I've used ERAZ92A filler on a couple saw cases, but I'm not an expert. I set my tig welder to 150 but then used the pedal to control...
-
I didn't find it too difficult to weld. I did heat the area pretty good a few times to sweat the oil & junk out of the crack. I did a...
-
Thank you Sir, that is very helpful.
-
I've welded up similar oil-soaked stuff, and the biggest thing as others have said is cleaning and surface preparation. Light...
-
I haven't done mag welding personally. Its described as like welding aluminum but trickier. I know it is best to clean away the paint...
-
Yes, that can be welded.
-
When I have encountered this very problem, a little more rich on the low side and a little more RPM on the idle screw fixes it 95% of...
-
Tor R replied to the thread Not so pros 4 new and without politics.Good afternoon, slobs, day two of birch timber driving, as usual I fill up what the timber claw takes, sometimes a little too much...