Tor R's latest activity
-
One trick that helps immensely with threaded fasteners into plastic, is to always turn the fastener counterclockwise or backwards slowly... -
That is definitely an application that could use it. 55 bulkheads are so easy to strip before you know you’ve done it
-
Thanks Mark, but is that even possible? LOL The credit actually belongs to @Termitebuffet from quite some time ago on another forum in...
-
Paying proper tribute to Poge.
-
i would also add to the carb update if you are drilling a hole in the cover you can leave out the plastic ring you just need shorter...
-
There were also parts to convert existing saws to the normal valve, or just use a plug. I converted every one I could get my hand on.
-
Couple of service bulletins I thought would go good on this thread. Most will already know about the changes, but it's sometimes helpful...
-
Red Repped his ass.
-
Doesn't matter what you like, that's a violation just the same. Gonna have to give you a demerit. :p
-
@Spike60 I didn't like the kink in the wire right where the eye is crimped on so I stuffed it through the hole where the clip is. Also...
-
Both wires should be under the clip, but above the air conductor. Here's a pic of one of my clean ones.
-
Aight then Fat Albert.
-
Tor R replied to the thread Not so pros 4 new and without politics.Good morning guys, I've been on the spin bike, the 70 minutes went really well. Then the physiotherapist looked at my knee, it's a...
-
Climbing on the tractor. Hay Hay Hay
-
Happy Birthday shoutout to @p61 western have a good one VeeP man! 🎂
