Tomos770's latest activity
-
I have been on that BITOG for for over 20 years. There are a few guys that know what they are talking about. The rest are a bunch... -
“Strip it out and then back it off a quarter turn” is a well-loved torque spec used by many.
-
Some girls faint over Michael Jackson The 564 fervor is real. I acutually fainted on my first attempt to pre-order the 564. For just a...
-
Haters gonna hate.
-
Tomos770 reacted to lehman live edge slab's post in the thread Husqvarna 564xp (g) fuel inject with
Like.
I think every pro Stihl saw has had one proprietary bearing in them for as long as I can remember. Granted it’s usually just a common... -
Just going off past experiences from here, he likely said something negative about red armor and everyone went apesh!t
-
I hate proprietary bearings.
-
Tomos770 replied to the thread Oil questions....Wonder what was behind the ban of user SonofJoe.....? He seems to be very informative as ex oil industry engine oil formulator....was...
-
They all leak a little bit. It’s not like it’s a “sealed“ system. As long as the proper gaskets are in place and the muffler isn’t...
-
You misspelled “put up with”
-
Tomos770 replied to the thread Ms362 exhaust leak..Tighten, tighten and strip those bolts.... :rolleyes: I like the post with a home made coper gasket.....or made out of klingerit sheet....
-
If you have any copper flashing/sheet, make a copper gasket and heat shield combo. I have never hade one leak yet . .
-
The bearings may not be the weakest point on the 5xx series, but the combination is all very fragile. It would have helped with the...
-
Almost anything is possible if you try. But when I go get gas there is usually 5 trucks, a chipper, 2 machines and multiple gas cans...
-
If it's got something similar to 6202 bearings then it's fine, most older 70 cc saws ran 6202 just fine
