Tomos770's latest activity
-
I would leave them in personally. Use a good mix oil at 32:1 and your bearings will be fine -
Tomos770 replied to the thread Makita exits gas equipment manufacturing.Old stock? They are 4.5euros over the border... https://unicommerce.si/zaboj-za-shranjevanje-verig
-
Tomos770 reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with
Like.
I’d like to see that. Can you find it again? -
You are correct that a dirt-bike type expansion chamber will produce the largest gains but just so you know …. Back in my day guys would...
-
Got a few more done 395 with restrictor thing removed and a lil red barn deflector 2 357/359 mufflers. One I removed the EPA stuff...
-
Blue mix is best mix.
-
JacktheStitcher 😁
-
Tomos770 replied to the thread Show off your muffler mods.jackthepiper :D
-
Not pretty, but not exactly too ugly… zap zap zapped it around
-
Indeed, but, even an engine with valves benefits from a well tuned exhaust. Cam profile affects that as well. Thats another rabbit...
-
A properly ported saw will usually create power at higher RPMS and will need a less restrictive exhaust ... it is about matching...
-
A simple way to think about it is the muffler outlet restricts flow. If you open it larger than another restriction in the saw, you’ve...
-
We might have to take this to a different thread because it’s a legitimate debate: Is back pressure valuable, or is it only helpful if...
-
I will respectfully disagree. I've discussed this with porters who are far more knowledgeable than I am. A hole in the front of the...
-
I agree. I like ported saws not so much for the speed anymore but so I can cut with a longer bar on a smaller lighter saw.
