Recent content by Tomo6400

How you going mate you wouldn’t happen to have any spacers left ?

They seem to be a nice A.M. cylinder mate I was given a few for testing.

Huskyboy so if you want to use the 395xp carb box with the 394xp set up you just need to drill a hole in the corner for the throttle cable to fit the carb is the correct thanks for your time.

S so do you raise the exhaust port again or just widen the ports a we bit ? And I noticed you said the cross pistons have wider skirts I haven’t found that and I put it against a ks piston and a Mahle piston have the changed them mike.?

Did you get any piston scuffing mike I just put a meteor in a kit and there’s a little bit of scuffing starting to show the first kit lost plating above the exhaust port.

Is your 066 cross cylinder and piston still on the saw mike if so have you put much time on it and how’s it holding up ?

Is it ok to run them straight out of the box randy the exhaust port roof does look a little flat but it’s a nice cylinder thanks for your time.