Recent content by timg

@Chris Riley

Merry Christmas All and Safe New Year OPE!! Not comparing presents Mark. But I got best one of all a couple of days ago. Dogs had a good morning too of course mother had to dress em up LOL!! Yinz take care and enjoy family time for sure!

@Duane(Pa) I've had good luck with thin wall keenserts from McMaster Carr. Drill super slow and straight with lube on the initial cut. I have broke a couple corners on the cylinder flanges initially.

I like your approach to this Greg. I know your a busier family man now. But, this site has needed some professional builder input for well into 6 Mos to a year now. Again thx for making the time. Looking forward to thread progress.

I'll bet. That was a good catch and fix with seals you had on hand from other bearings. I've only used one aftermarket set of bearings on these. They were the same width and color brown as OEM of rubber shell bonding material. This tip you supplied will save someone as arsz ache in the future...

Looks as if we were typing at the same time LOL.

@Shane¹ I too am looking for some clarification on your mod. Did you add another seal over the integral bearing/rubber coated cup with the integral seal and used it as a width spacer?

I hope we all can enjoy a little food, family time, desserts, and maybe a Nap. Reach out to neighbors if short on family. Times change but giving "Thanks" is shareable.

Great 70cc project.

Some of my contacts charge 30 to 35 per drive link. @Bill G curious on your rate for 3/8 .050 loops. I didn't know you were making up loops. I'll keep that in mind.

3 Hours in and it's still here. Never would of thought this. @ajschainsaws

Good eye @Maintenance Chief. Your exactly right sir. Did yinz notice his Homelite red brimmed hardhat?

I'm sure you would figure out how to stroke and toss off @sawmikaze. Neatsfoot oiled

Them legs ain't getting any younger sir. Happy B Day @Tor R