tek9tim's latest activity
-
Ttek9tim replied to the thread T&S CZ223 review.
-
-
Ttek9tim replied to the thread T&S CZ223 review.So my problem with the dressers is that they're single point and not the same as the ones for a Simington or Silvey, so can't just swap...
-
TStihl Ultra at 50:1 only. It's good oil if used correctly. Not great oil....but good.
-
Ttek9tim replied to the thread T&S CZ223 review.I mean, the Simington is $1600. Adjusting for inflation, $2300 matches up to what the Silvey SDM went for, adjusted for inflarion, when...
-
Ttek9tim replied to the thread T&S CZ223 review.Yeah, I like the idea of CNC machining the parts, bolting them together, and using linear bearings for movement. Also no play in the...
-
Ttek9tim reacted to Dolkitafreak's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with
Like.
I disagree. And I know a lot of folks are fast to say you don’t want any lean or only 3 degrees, I found that chains like that don’t cut... -
Ttek9tim reacted to srcarr52's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
You can also raise the slide (on my RSII kits) or lower the stone arbor so the chain makes contact with the stone further down on the...
-
Ttek9tim replied to the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets.I bit the bullet at work, started a separate thread on it. TL;DR- I like it, but needs improvements like every other square grinder.
-
Ttek9tim reacted to Hedgerow's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
Eh.. It’s the Indian, not the arrow.. But that thing looks like it could get the job done.
-
TLike anything, pros and cons. It cuts slower for one thing. On most saws anyway. Over 90ccs might be a different story, but under that...
-
TIt was pretty hard to find any info on the relatively new CZ223 square grinder, so when there was some money in the work budget for a...
