stretch5881's latest activity
-
Spent two hours putting a master cylinder in my wife’s car just to realize there’s an o ring on the back of the master cylinder I didn’t... -
stretch5881 reacted to legdelimber's post in the thread Random pics (that you took) thread... with
Haha.
The floor has a good texture for the crayons. But even better is that it don't slide back and forth the way the coloring book does! -
stretch5881 reacted to Yukon Stihl's post in the thread Random pics (that you took) thread... with
Like.
We just got our sunshine back The sun hides behind our mountains all winter. Yesterday it came down beside the mountain direct sunshine... -
stretch5881 reacted to jacktheripper's post in the thread Random pics (that you took) thread... with Like.
Today
-
stretch5881 reacted to cgraham1's post in the thread Random pics (that you took) thread... with Like.
-
stretch5881 reacted to Only the Tony's post in the thread Random pics (that you took) thread... with Like.
-
I looked at this truck on Monday for a no start. The rear crossmember went to chow town on the fuel pump module wiring. I had looked at...
-
stretch5881 replied to the thread Random pics (that you took) thread....Good candidates for Wellers.
-
stretch5881 reacted to redline4's post in the thread Random pics (that you took) thread... with
Wow.
This the new rusty junk thread? -
Anyone here?
-
stretch5881 reacted to FederalQ's post in the thread Random pics (that you took) thread... with Like.
😁As long as all the safety features are in order I will keep using it as a plow truck. Cab corners have spray foam insulation that will...
-
Been a hard week on the checkbook. I purchased 59 307lb calves on Wednesday. Thursday I purchased an EAVision J150 spray drone and...
-
-
ISO12.9 grade bolt shaft to adapter sleeves. Solid-Carbide 18.0mm drill bit just laughed at it spitting out orange glowing fingernail...
-
stretch5881 replied to the thread Random pics (that you took) thread....Must be a rust challenge. 😆