Squish9's latest activity
-
SRun what is locally available
-
SOverseas .058 is very common (about 1.5mm), but here in the US it is by far the least common. I personally don't see any advantage to...
-
SSquish9 replied to the thread Chain gauge.Yep, it's the lower that changes. Oregon is 050 and 058 same with a coined (thinned) drive tang below the straps. Their 063 is bigger...
-
SSquish9 replied to the thread Chain gauge.Run whatever is most common in your area because it will be the cheapest. I run 058 and 063 because 050 is uncommon here so there is a...
-
SSquish9 replied to the thread The Small Dolmar/Makita Thread..Max 50cc class.It's just out here being helpful. Wish the oil fill hole was bigger to suit my combi can, other wise it's pretty awesome for a 34cc saw
-
-
SSquish9 reacted to old_sir_henry's post in the thread The Small Dolmar/Makita Thread..Max 50cc class with
Like.
Interesting, according to the lists I have the "DE" models don't have a chain brake, but maybe there have been different configurations... -
SSquish9 replied to the thread The Small Dolmar/Makita Thread..Max 50cc class.Is this how your ment to use the small saws? I like this little thing. Couldn't quite get the bottom and had to break it off
-
-
SSquish9 reacted to Duane(Pa)'s post in the thread The Small Dolmar/Makita Thread..Max 50cc class with Like.
-
SSquish9 replied to the thread The Small Dolmar/Makita Thread..Max 50cc class.The chain brake is in the side cover. Am I right in thinking these are based off the 100S?
-
-
SSquish9 reacted to old_sir_henry's post in the thread The Small Dolmar/Makita Thread..Max 50cc class with Like.
Interesting find! That's yet another sibling in this family of saws. Does it have the sprocket cover without built-in chain-brake (67)...
-
SSquish9 reacted to Hulsty's post in the thread The Small Dolmar/Makita Thread..Max 50cc class with Like.
I see a few of those for cheap around my way, just I dont really need anything smaller than my 4300F
-
SSquish9 replied to the thread The Small Dolmar/Makita Thread..Max 50cc class.Found this little guy for $30 and couldn't say no
-
-
SUnfortunately, I don't know when. It looks as if the launch will probably not be simultaneous with Picco Hexa, as information about the...
-
SThey will be available in .050''/1.3mm. The model number of the 23 RH is 3140, 23 RH3 is 3141.
-
SWill these work in 5amp black and decker drill? Or can I just twist them with my fingers to get the job done?
