South_Prairie_Saw's latest activity
-
South_Prairie_Saw replied to the thread Holzfforma 3120 Thread.Going back I would have tried to find an 880/088. Seems parts for these aren’t as easy to find as I had hoped. -
South_Prairie_Saw replied to the thread Holzfforma 3120 Thread.Well it didn’t take long for our first catastrophic failure, and not sure it could have been much worse. Keep in mind this saws only...
-
I think they are really nice looking parts but the price point is tough to swallow. If you buy a muffler mod from the typical porters...
-
South_Prairie_Saw reacted to Only the Tony's post in the thread So does anyone fish or just nah??? with
Like.
Finishing 2025 fishing this morning. -
I often see videos of guys in the PNW running long bars on small saws.
-
I use a 20 inch on mine but I cut a mix of hard and soft timber. It destroys any timber. Sorry to hear about your father passing away man.
-
South_Prairie_Saw replied to the thread Trees you've cut.I think I could easily run a 28” on this out here, I have a 32” that would fit but haven’t tried it. It feels pretty perfect with the...
-
South_Prairie_Saw replied to the thread So does anyone fish or just nah???.Well it’s winter steelhead season here in the PNW, haven’t been out in a while so spending some time getting some fresh jigs and leaders...
-
-
South_Prairie_Saw reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
Here is the negative of a Husky 365/372 case gasket I cut with the Cricut: Here a test run of a carb gasket for the Prentice-Reed...
-
South_Prairie_Saw reacted to hacskaroly's post in the thread MCCULLOCH The official McCulloch thread with Like.
I draw them out in Adobe Fusion and then use my wife's Cricut to cut them out. Nice crisp edges, much better than what I get trying to...
-
Cross cylinders was the brand. As I remember, the first preproduction ones they shipped to Randy were really nice, good enough to get...
-
Shrinking an aftermarket 460 3/4 wrap for my 026. 3/4" out of the width, need to drop the top about an inch. Good TIG practice anyway.
-
What would be cool if some company would make a quality aftermarket cylinder ( material same as OEM ) that meets material specs &...
-
I am gonna have to respectfully disagree , I think they design & engineer them conservatively for multiple reasons. But thats just my...
-
South_Prairie_Saw replied to the thread RIP Saw 500i.Yes obviously. I’m more confused by you stating that “they” designed, cast and machined a cylinder. Rip saw? Are you asking why stihl...
