Sloughfoot's latest activity
-
I remember when company logo caps we r e a gimme rather than a product. -
I bought another saw today that will consume my time finding parts. It sounded mean with a shot of gas in the spark plug hole though.
-
Sloughfoot replied to the thread Stihl 361 Leaky Carb.I've got that one. It works great for pressure testing these little carbs. Kinda slow airing up footballs and basketballs though.
-
Tip- Soak gaskets in fuel mix prior just to installation so they will swell and seal as well as make sure they are on the proper side of...
-
I have fixed a couple of holes in tanks using JB Weld applied from the outside only. Just make sure it's roughed up a little, is clean...
-
I would thread it with an 1/8 inch pipe tap then screw a brass plug in with loctite on it until it tightens up then grind the outside flat.
-
Sloughfoot replied to the thread Fixing hole in tank.I would think if pressed in fuel lines and tank vents don't leak then a tight fitting low profile rubber plug you could drill the tank...
-
Shining a flashlight into the tank, there is luckily no corrosion inside of the tank. There is just a very minimal amount on the bottom...
-
Depends on things for me. I’ve done smaller ones unwrapped but most times I wrap them. I’m starting this one at 5 pm tonight as I want...
-
This was 23 pounds before the trim. Probably still 18-20 pounds and it will go on shortly at 225 overnight.
-
Sloughfoot reacted to Czed's post in the thread Funny pic's and gifs 2021/2022/2023/2024/2025/2026 with
Haha.
https://www.reddit.com/r/TikTokCringe/s/ACK3sRRa1X -
I just picked up an Innova 3100RS in a pawn shop for 25 bux. Regularly 139.95, reads abs, airbag, and has some bidirectional control on...
-
Mister Rumbles, our first barn cat:he used to let me drive his truck now and then.
-
Breakfast with the leftovers:
-
I wouldn't modify the intake. That's not what's holding this saw back. Make sure you give it a generous muffler mod; this is where the...
