Sloughfoot's latest activity
-
-
Sloughfoot replied to the thread What's on your bench?.I wouldn't want your 2100 experience to be that easy.
-
Don’t worry, I’ll take it for you!
-
Sloughfoot replied to the thread What's on your bench?.I may have done similar to my 2100.
-
Piston and cylinder were fine. Crank was fine. I got lucky. Cases cleaned up, old bearings removed. Ready for reassembly tomorrow with...
-
‘Other place’ got too much into politics. I like communist chainsaw folks; socialist chainsaw folks; capitalist chainsaw folks...
-
Sloughfoot replied to the thread VOTE NOW WHY DID YOU JOIN OPE.to catch a predator
-
Sloughfoot reacted to redneckhillbilly's post in the thread VOTE NOW WHY DID YOU JOIN OPE with
Like.
I wanted to learn about new saws and how to properly keep them running from the people that use them daily and repair them daily. every... -
I came here because all my buddies got booted from AS
-
I was invited over by a member - it's turned out to be a pretty good spot on Al Gore's Interwebs.
-
@chipper1 does that so he can take a break sooner 👍👌😂
-
Be careful on max oil setting or you will run out of oil before gas. I believe it’s been mentioned in here a few times that you can...
-
Easy said when your health is ok, not so easy when your in agony, two three sales agreed then bam, your world is upside down.
-
Sloughfoot reacted to dieselfitter's post in the thread Gun range 2022,2023,2024,2025,2026 with Like.
I made a swivel base for a friends vise. I used the ball from a scrap heim joint. It turned out nice.
-
Replaced a u-joint on my Ranger . It had been so long since I did this task I forgotten what a miserable job it was . I used a GMB...
