sixonetonoffun's latest activity
-
sixonetonoffun replied to the thread WANTED Jonsereds 70e brake handle.My bad looks like I was scammed. Stuff happens. So still looking. -
The 550 & 562xp’s do most of the fire wood bucking, unless it’s a monster log. Felling is usually the 565 that’s now quite a zippy...
-
Was that Dongo?
-
I believe he was sending messages with shady Gmail address in response to wanted adds.
-
As for size and type, I tend to run 67-76cc saws with 24” bars and full wraps as a standard for firewood. Most of my firewooding...
-
Main saws at present: MMwS 500i, Stumpshot 372xp, Dozer Dan 346 (45cc). I cycle through some of the others every now and then.
-
036 is the most used. Small stuff a 028S or 026. Bigger wood 038M. Don't cut much huge stuff but have 056M and 066 for that.
-
Why?
-
Depends on specific target. 50cc for limbing/branch wood bucking & trail maintenance. 60 or 70 for log bucking or noodling. 80 for...
-
I've been grabbing my 2065 for firewood more and more. It doesn't feel as bulky as my 044, and smooth enough that it's not too...
-
I usually end up taking 3-4 out for any given cutting occasion. I'm partial to the ported 50cc saws primarily of the 346xp variant. If...
-
I would leave them in personally. Use a good mix oil at 32:1 and your bearings will be fine
-
Because it seemed less crazier than the other place 🤣 Started AS and OPE around the same time. Although many members were on both...
-
Is there a CBN raker wheel for USG grinders?
-
Hit them with a round grinder that is set up at 90°,then file them. Be sure to leave the shelf in the side plate/ gullet junction to...
