singinwoodwackr's latest activity
-
Ssinginwoodwackr replied to the thread HELP! Stihl 020av fuel seepage around the fuel tank gasket..Try lapping that half on a skeet of thick plate glass using 220g paper. That will show any “channel’ that might cause a leak. The weight...
-
Ssinginwoodwackr reacted to Mendocino Redwoods's post in the thread WANTED Husqvarna 266xp cylinder with
Like.
I’ll pay whatever you want as long as you take checks 😂 -
Ssinginwoodwackr replied to the thread So what did you buy today.Well, unless the thing was never used, an early 90s 066 wouldn’t be that new. That saw shows plenty of use. Mine’s on its 2nd piston.
-
SYes, has the thin base KS cylinder.
-
SFound a Red Light. Really dirty but should clean up nicely.
-
Ssinginwoodwackr replied to the thread So what did you buy today.Well, that piston isn’t the original but might be oe replacement, stock cyl?
-
Ssinginwoodwackr replied to the thread So what did you buy today.Those look like something from SF…
-
Ssinginwoodwackr replied to the thread So what did you buy today.I got my bill from them for a Canuckistan purchase…not as bad as expected. FedEx, on the other hand, sent me a big bill for an EU...
-
SI got this 262xp today for $367. Seller said it would start but run rough thought it needed carb kit. It was filthy so it took it apart...
-
SWith or without shipping :risas3:.
-
S$265 with shipping , and I'm busting the bank for that number. :sconf: Hope someone wasn't looking over my shoulder.
-
Ssinginwoodwackr replied to the thread SOLD Stihl ms 241c.$250 and I’ll send you a Pirateship label.
-
SI often blow some glass beads down the transfer tunnels in a cylinder after I port the transfer ports, just to clean up any casting...
-
Ssinginwoodwackr replied to the thread SOLD Stihl ms 241c.$251…
-
Ssinginwoodwackr replied to the thread WANTED Husqvarna 266xp cylinder.How much ya wanna spend? :p
