singinwoodwackr's latest activity
-
Ssinginwoodwackr replied to the thread Ms661 muffler mod/baffle removal?!?!.I’ll have to look at mine…been a while
-
Ssinginwoodwackr replied to the thread Ms661 muffler mod/baffle removal?!?!.Just enlarge the holes…unless you port it.
-
SAt 0° F you should be inside enjoying the fire, not outside cutting wood...
-
Ssinginwoodwackr replied to the thread SELLING Husqvarna 261/262xp Rattler ported..Only by ship…
-
Ssinginwoodwackr reacted to PA Dan's post in the thread SELLING Husqvarna 261/262xp Rattler ported. with
Like.
Pics -
Ssinginwoodwackr reacted to PA Dan's post in the thread SELLING Husqvarna 261/262xp Rattler ported. with Like.
Up for sale is a very clean 261/262xp with a Rattler ported cylinder. I converted this with the ported cylinder and a new Meteor...
-
Ssinginwoodwackr reacted to jacob j.'s post in the thread SELLING Husqvarna 2100, 285 etc cylinder shroud with Like.
That you need to build and start cutting timber with...
-
Ssinginwoodwackr replied to the thread SELLING Husqvarna 2100, 285 etc cylinder shroud.I have 2…in boxes… 1 just needs to be assembled...thin ring piston :D #2 needs a cyl
-
Ssinginwoodwackr reacted to hacskaroly's post in the thread SELLING Husqvarna 2100, 285 etc cylinder shroud with
Haha.
Looks like the bobber just went under the water...quick....set the hook!!! 🤣 -
Ssinginwoodwackr reacted to LS50713's post in the thread SELLING Husqvarna 2100, 285 etc cylinder shroud with Haha.
Follow the Rabbit Hole, I have one for sale or maybe even 2 of them.
-
SThis saw is practically new. It’s made two cuts into a 12” oak log. I got this a few months ago, manufactured in 2025. I paid $1325 for...
-
Spm sent
-
Ssinginwoodwackr reacted to SawAddictedFarmer's post in the thread Husqvarna 346xp NE piston problem with Like.
That's fine. Get some red armor or dominator oil and run it at 40:1.
-
SSummer chainsaw finished, got a few new parts….case, fuel tank, top cover, handlebar, start cover, brake flag, oil pump, clutch, boot...
-
Ssinginwoodwackr replied to the thread HELP! 500i UPDATE !.Done that…didn’t quite get the crank completely seated on one side…oops. Disassemble and redo…problem solved.