singinwoodwackr's latest activity
-
SBottom drawer of my tool case has been difficult to shut for a couple of years. Pulled it out other day and found 3 tools I've been...
-
Ssinginwoodwackr replied to the thread What's on your bench?.I can try, with the welding tip kit when I find it, lol. But, the aluminum oxide is pretty bad. Good thing is the needle seats are not...
-
SI run a wire from a repair tag down into those as far as I can.
-
Ssinginwoodwackr replied to the thread What's on your bench?.Somewhere, lol Found it…on the oxy/acl cart, duh…
-
SThis Remington SL11 was pumping a lot of air and very little oil. The pickup in the tank was pretty plugged and the line from the oil...
-
SIt has been a while since I have assembled those, but you might want to check, the inner shaft may be different (different mating heads...
-
Ssinginwoodwackr replied to the thread HELP! Ht133 pole saw.Which is why a friend’s tree service has dumped their Stihl’s for Echos. Half the price and easier to work on…and, parts show up at the...
-
SI’ve worked on quite a few Stihl pole saws over the years, but mostly 130’s and 131’s. I pretty much have to relearn each time, because...
-
Ssinginwoodwackr replied to the thread What's on your bench?.I can get the larger ones with carb brushes. The tiny, .030 passages into the body of the carb, not so much.
-
Ssinginwoodwackr replied to the thread What's on your bench?.The corrosion is localized to that one section. I wire brushed a lot of it off after quite some time in the sonic tank. But, how much is...
-
Ssinginwoodwackr replied to the thread What's on your bench?.Hmm....don't think I can salvage this one :( Way too much corrosion.
-
-
Ssinginwoodwackr reacted to Sloughfoot's post in the thread Questions regarding CA internal combustion engine ban with
Haha.
I've gotten some parts and double bevel files from them a couple of times. Their repair shop has a good reputation. At nearly 4K... -
Ssinginwoodwackr reacted to Woodslasher's post in the thread Questions regarding CA internal combustion engine ban with
Like.
I know of a well-established saw shop in the region run by a handful of retirement age guys who would probably be happy to see it change... -
Ssinginwoodwackr replied to the thread What's on your bench?.Well...it seems to like a fleese filter rather than the fine mesh. 10-10,5 in the cut without any pressure added. 18" maple...
-
-
SThey are mirror polished when made, and while they won't remain so forever, a dull look is okay, but a rough "weathered" finish could...
