singinwoodwackr's latest activity
-
Ssinginwoodwackr replied to the thread Grinder Comparison Thread.Well, it seems you cannot order just those little posts…have to get the whole $30 kit. maybe I can weld something to a bolt head... 🙄
-
Ssinginwoodwackr replied to the thread Grinder Comparison Thread.It depends on how much the gang uses the Feller-buncher.
-
STree Monkey question: If 2 identical saws were ported: same exauhst roof same transfers same intake timing. One saw had .040 squish and...
-
SAnd now … back to our regularly scheduled program
-
Ssinginwoodwackr replied to the thread Holz Lw bars?.Definitely.
-
SFor $80 its worth a try
-
Ssinginwoodwackr replied to the thread Holz Lw bars?.They even copied the stupid Stihl paint job, lol
-
S:icon_popcorn:
-
Ssinginwoodwackr replied to the thread Grinder Comparison Thread.Got the 520 jaws kit today. However, the only parts that are different are the 2 posts. That's all I actually needed 🙄 The jaws are the...
-
-
Ssinginwoodwackr reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
He could have a weak spring below the metering lever also not holding enough seat pressure because pop off is too low. All depends if it... -
Ssinginwoodwackr replied to the thread STIHL The Official Stihl Chainsaws Thread.What does the L needle and its seat look like? I had one with similar symptoms and the needle had a little rust on the end but, the...
-
Ssinginwoodwackr reacted to bogieboy's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
This is the mechanic in me.... bigger rattle gun would likely get it too (assuming the OP hasnt hit it with a snapon mg725 or the like...
-
Ssinginwoodwackr reacted to justoldsaws's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Low hour ms460, picked it up cheap due to the damage around the clutch. The remnants of the clutch spider is stuck, Ive had a socket...
-
SSaw had been sitting when I acquired it, probably needs a fuel system overhaul. Piston looks excellent through exhaust port. Hast the...
-
SNothing like a clutch burnout on the shop floor
