singinwoodwackr's latest activity
-
Ssinginwoodwackr replied to the thread Grinder Comparison Thread.Got the 520 jaws kit today. However, the only parts that are different are the 2 posts. That's all I actually needed 🙄 The jaws are the...
-
-
Ssinginwoodwackr reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
He could have a weak spring below the metering lever also not holding enough seat pressure because pop off is too low. All depends if it... -
Ssinginwoodwackr replied to the thread STIHL The Official Stihl Chainsaws Thread.What does the L needle and its seat look like? I had one with similar symptoms and the needle had a little rust on the end but, the...
-
Ssinginwoodwackr reacted to bogieboy's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
This is the mechanic in me.... bigger rattle gun would likely get it too (assuming the OP hasnt hit it with a snapon mg725 or the like...
-
Ssinginwoodwackr reacted to justoldsaws's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Low hour ms460, picked it up cheap due to the damage around the clutch. The remnants of the clutch spider is stuck, Ive had a socket...
-
SSaw had been sitting when I acquired it, probably needs a fuel system overhaul. Piston looks excellent through exhaust port. Hast the...
-
SNothing like a clutch burnout on the shop floor
-
Ssinginwoodwackr reacted to PA Dan's post in the thread Ms362 base gasket delete and timing advance? with Like.
If it's cast onto the flywheel use a small square needle file. I mark the key with a black marker so I can see how much im taking off...
-
SIf my 50-60cc saws see anything over about 2/3 the length of the bar (i have 5 in the 50-60cc range, 026, ms261, ms362, and husq...
-
Ssinginwoodwackr replied to the thread Ms362 base gasket delete and timing advance?.Same here, 2 different builds
-
Ssinginwoodwackr reacted to bogieboy's post in the thread Ms362 base gasket delete and timing advance? with Like.
Gotta check squish, when i rebuilt my ms362 i was going to gasket delete it... reassembled with the new piston (aftermarket for what its...
-
Ssinginwoodwackr reacted to FederalQ's post in the thread Ms362 base gasket delete and timing advance? with Like.
The key appears to be part of the flywheel like the 361. The stock base gasket looks to be 0.5mm or .020“.
-
Ssinginwoodwackr replied to the thread Ms362 base gasket delete and timing advance?.Yes on the solder. Find out what the sq is first.
-
Ssinginwoodwackr reacted to farminkarman's post in the thread SELLING Tree Monkey 395XPG new price $1800 + shipping with Like.
I think he needs a 3120 for his boat
-
Ssinginwoodwackr reacted to MR_T's post in the thread SELLING Tree Monkey 395XPG new price $1800 + shipping with Like.
