SimonHS's latest activity
-
The 350CS is cleaning up nicely, but the piston is done. For whatever reason, these were built with a plain bore cylinder and chrome... -
SimonHS reacted to Wilhelm's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with
Like.
I cut Turkey oak almost exclusively and going to 25° from the somewhat standard 30° was a noticeable game changer for me. Longer lasting... -
SimonHS reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Oregon says that it absolutely makes a difference, with some chains, under controlled test condition conditions. I never noticed a...
-
This Remington SL11 was pumping a lot of air and very little oil. The pickup in the tank was pretty plugged and the line from the oil...
-
Hmm....don't think I can salvage this one :( Way too much corrosion.
-
Well...it seems to like a fleese filter rather than the fine mesh. 10-10,5 in the cut without any pressure added. 18" maple...
-
Some Pioneer parts came in.
-
Mag II is back in business. New Dukes piston and OEM rings. Also, needed a new oil pump and spur gear and a couple other smalls.
-
-
nice finish. Does the outlet port not hit the brake when it's pushed down? I do mine similar but more to the front not at this time...
-
Husqvarna 572XP
-
Well damn, It finally happened. I got scammed through Facebook…. I’m pretty sure it was a real person, we talked on the phone. Went...
-
Today I installed my last two parts for a Husky 365 that I bought from @redneckhillbilly (great guy to buy from!!). This was a fun...
-
finished today I had to modify the smaller pipe a little because at my first try the angle wasn't that good and therefor the...
-
Made a stand for my squish cutter so I didn't need to use the vice in my work van. Then got squish band cut for 7900 with solo crank.
