SimonHS's latest activity
-
Probably just going to get a simple hockey tape job. Got the top dropped, had to order a little tubing to finish the leg back by the... -
The other Jonsereds 910e is also cleaning up nicely. Replaced a rear AV bushing and rear handle assembly. This is going to get new fuel...
-
The 450 is starting to look a lot nicer. I have been repeatedly washing and scrubbing it to get the caked on crap off. It’s probably the...
-
I can't say it more loud and clear: FÜCK AI. It's probably going to end my wife's career at some point, and make all of our lives worse.
-
One of the dirtier saws I’ve seen recently. The stuff was caked on so hard that a pressure washer wouldn’t take all of it off.
-
-
Echo 9010 blower crankcase. The fan side bearing is a good Japanese NTN but this is the second one I’ve seen with a failed cage. Both...
-
Shrinking an aftermarket 460 3/4 wrap for my 026. 3/4" out of the width, need to drop the top about an inch. Good TIG practice anyway.
-
But there’s only a few that understand reality whether it’s now or 1960, i’m pretty sure it was called. Make *s-word happen!!
-
Merry Christmas to Me!
-
Redid the muffler on my ported MS460. Of note-I went through with a round file and cleaned up my edges-I am not a savage. I just didn’t...
-
The larger 1/2" ratchet is better because it has speed control in the button / 2x15$ body
-
Well the time had come to get a new ride. 2021 Tacoma 4x4. Price and miles were right. Plenty of factory Toyota warranty left plus...
-
So glad my wife owns a nail salon, nothing but time in the garage. Yes, she’s Vietnamese. Aren’t they all?
-
If you carefully remove the plastic clamp part on the intake flange and bevel the ends of the platix ring you can fit a steel clamp. Ive...
