SimonHS's latest activity
-
A good C3 rated bearing from any accredited bearing manufacturer will be fine. You have to be aware of counterfeit fakes that are out... -
Those are clutch removal tools. :thumbsup: Heavy duty, solid steel milled.
-
Those little shiny hanging down things? They are my circlip installers for piston pins. 9-13mm I need an 8 to have a complete set (I think).
-
My bench is so crammed I can't sit on it. They need sharp burs knocked off.
-
I also went through my new barn find white top 61 practica. I removed the muffler baffle, replaced the coil, rebuilt the carb, and...
-
Today I got the crank case together with new bearings. I’ve always used a sealant like dirko on the case gasket, but this will be an...
-
Nice size Ash killed by the EAB. Hooked up the tractor when dad was out feeding cows and got it pulled out to flatter ground for cutting.
-
This wasn't funny. :confused: Called it quits after the fourth 7.0mm end mill committed suicide. It is a proven milling program, I...
-
Since 12/4/2015 it's been TEN WHOLE YEARS to the day that OPEforum has be open to the public. Our goal remains the same: (1) HELP...
-
Jred 630V. This was a raffle saw I won a couple years back (not a runner). I got it running and found out the clutch drum was shot and...
-
-
I agree I live my life doing that These are made of metal and I salvaged them to build a shop out of them. Footings are done next...
-
Some weeks back a fellow traded me an anvil in exchange for putting his 285CD back together. He said it just locked up when he was...
-
I try to leave the shop and museum open even when I am gone for a few hours in case someone stops by and wants to look around or leave...
-
026 and 066
