SimonHS's latest activity
-
My bench used to be a 200L oil barrel 😎👍 Or the catering table is quite high like mine 🤠 I still have them -
So instead of trying to reused the steel line I made some fittings and used some good rubber tubing. I found the bar clamp but...
-
I've been working on getting the Clinton CS424 back together, see post 35,543 for the beginning of this project. According to Acres...
-
The Homelite 550 ran well for about two minutes before developing an air leak. I thought it might be the modified stihl crank seals I...
-
SimonHS replied to the thread Connection/running Issues 560xp.There are fake spark plugs out there. Cheap counterfeit Chinese plugs with fake branding. No way they could offer the same performance...
-
Chlorine did a number on it. Pool tech told me those things will last if you only have them in when you run them but if you leave them...
-
Not sure on that one. The motor casing did not appear to have any signs of a leak. The seal is installed with the back side of it...
-
The complete servo unit looks like this and will have a new board inside.
-
Interesting times on the bench this week. My wife told the neighbor that I like to fix things. Next thing I know is I have a Dolphin...
-
Finally an update on this lads, It turns out that I had a string of bad plugs and the final one I put in fixed the issues. Much...
-
Coupla pairs boots are sidelined: Timberland Evergreen loggers: That synthetic heel counter is beating the crap out of the back of my...
-
I have used the cj7 tailgate for a long time until recently getting my bench in place
-
Wait till you see the F-150 tailgate!
-
SimonHS replied to the thread HUSQVARNA HUSQVARNA THREAD.Another thing to try is heating the broken bolt with a soldering iron. A few heating/cooling cycles might help loosen things. To get...
-
Thanks for the recommendation! My current left hand bits I've been using are quite cheap, so I've got some nice cobalt ones showing up...
