SimonHS's latest activity
-
Good Luck. -
One longer project is finished, actually started 6-7 years ago when cylinders were very cheap. It will be ported when I have worn out...
-
What can you get at the poopty?
-
Picked up a clean old Toro 2 stroker mower 1987 vintage for $75. Everything works perfectly on it. Suzuki 2 stroke engine. Just grabbed...
-
The original Efco head and brass guides were too good, so they were replaced with aluminum
-
I found a bracket and handlebar that fit, I'm not always so lucky 😉 now I have to remove the switch because it's digging into my leg. I...
-
This little toy cuts surprisingly well, someone even played a trick on it and put a 3mm line where 2.4 is already too much. Now you need...
-
For 340/345 conversion. I was planning on one, but got a couple of bases in the mail today....
-
Jonsereds 111S’s if anyone is interested. FB marketplace Two Rivers, WI
-
Broke down and purchased 6gal of Mystik bar oil. We’ll see how it does.
-
At least I saw what the air filter looked like 😉This is how the H screw is signed
-
Heya David. Freehand in soapstone.
-
SimonHS replied to the thread What's on your bench?.This might help. It gives instructions for adjustment at idle and WOT. https://www.walbro.com/wp-content/uploads/2016/01/WZseries.pdf
-
It actually starts better with this black button, even though the string is short. However, the seal needs to be replaced - there is one...
-
