Shane¹'s latest activity
-
SActually the 2100 could have either the Bosch or the SEM ignition, as well as one other, the name of which escapes me right now. Each...
-
SShane¹ replied to the thread Looking for ideas on broken stud removal.I'd weld a flat washer to it then a nut and I bet it will spin right out
-
SI have had some success using a small end mill to create a flat surface, then drilling the broken bolt/stud enough to get and easy out...
-
SJim, My suggestion is drill out to maximum size without disturbing threads. Very small lengthwise ball burr straight line of remaining...
-
SWhat you are looking at is an exhaust stud broken off below the surface in an otherwise serviceable 66mm 090 cylinder. How would you...
-
SShane¹ replied to the thread HUSQVARNA HUSQVARNA THREAD.That was me. If the foggy sail repair does not work this usually does unless the coil is bad which is pretty rare only had it happen to...
-
SYes, that is what I think he is referring to and the chip used with this mod.
-
SAny chance that this is the photo in question? red/orange silicone on the ignition plate, after the repair...
-
SCan you guys tell me what chip to get and the wiring.I am guessing one of the chip wire goes to the little wire come out of the coil...
-
SI think the red silicone (permatex) is there just to protect the solder joints from corroding down the road.
-
SShane¹ replied to the thread HUSQVARNA HUSQVARNA THREAD.Is there supposed to be a picture attached?
-
SLooking for a working Bosch style CD ignition for our friend @mirage 285 CD.
-
S@Jay Hansen
-
S@jimstihl ?
-
SShane¹ replied to the thread FOUND IT Husqvarna 285 CD ignition.Did anyone try the foggy sail fix on it? Do the flywheel fans bolt on the 285s like the dolmars?
