Shane¹'s latest activity
-
S3 done, work for tomorrow buy epoxy glue and finish them,
-
SShane¹ replied to the thread Favorite semi skip chain.I have some 75exj Oregon full skip chain if you get a .063 bar I could make you a loop of it
-
SI don’t want to sharpen a 92 full house to be honest. If Dukes had a bar and chain combo in 28 with full house I would probably go...
-
SShane¹ replied to the thread What's on your bench?.Heated handle 7900 solo stroker started port work. Got most of it done might raise transfers just a touch more.
-
-
SShane¹ reacted to EFSM's post in the thread HELP! makita DCS460 dies when choke is opened with
Like.
If it has a rubber main jet check valve, that could have swollen and plugged the man jet. But you said all passages were open, which I... -
SShane¹ reacted to cuinrearview's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
Yours doesn't have one
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
The muffler is silver. The diaphram that operates the metering lever is on gasket first, then diaphram, cover. The diaphram with the...
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
I wish I had an alternate carb to use. This one a zama, has levers on throttle shaft & choke shaft that lock together when the choke is...
-
SShane¹ reacted to cuinrearview's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
Is the muffler a bronze color or silver? While unlikely, it's conceivable the cat in the later muffler could clog. But it still sounds...
-
SI picked up a few of these on eBay over the years for spares for the mag case models
-
SShane¹ replied to the thread HELP! makita DCS460 dies when choke is opened.Id try opening up the low speed jet some and ideally swap on a known good carb
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
All of the trials I did were with the air filter off. Which by the way looks brand new. Like the rest of the saw!
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
Just the baseline. SSM says 1 1/2 turns out (that's where I set it). Didn't check muffler. Checked spark ...it easily will jump a 3/8"...
-
SI have heard of stuffers on 346 crank. Where do they come from, some other model?
-
SShane¹ replied to the thread SELLING Dolmar ps 460 #2.Can't believe someone doesn't need a running saw for $125? Practically giving it away
