Shane¹'s latest activity
-
SI picked up a few of these on eBay over the years for spares for the mag case models
-
SShane¹ replied to the thread HELP! makita DCS460 dies when choke is opened.Id try opening up the low speed jet some and ideally swap on a known good carb
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with
Like.
All of the trials I did were with the air filter off. Which by the way looks brand new. Like the rest of the saw! -
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
Just the baseline. SSM says 1 1/2 turns out (that's where I set it). Didn't check muffler. Checked spark ...it easily will jump a 3/8"...
-
SI have heard of stuffers on 346 crank. Where do they come from, some other model?
-
SShane¹ replied to the thread SELLING Dolmar ps 460 #2.Can't believe someone doesn't need a running saw for $125? Practically giving it away
-
SShane¹ reacted to cuinrearview's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
What's it do with the air filter off?
-
SShane¹ replied to the thread HELP! makita DCS460 dies when choke is opened.I see you mentioned you adjusted high speed. Did you adjust low speed at all? From what you described sounds like a carb issue still...
-
SShane¹ reacted to bpmaas's post in the thread HELP! makita DCS460 dies when choke is opened with Like.
I'm stumped. Symtom : engine dies when choke is opened (can only keep it running by holding butterfly almost closed). No amount of...
-
SIf bling is considered anything that didn’t come factory then yeah. I put more dollars in AMS equipment on it than I paid for my first...
-
SI went out and rode around the mountains
-
SYou'll like this.. 2025 Suburban, 3.0 diesel, 3700 miles. Crank thrust bearings gone...
-
SYeah, doing injectors on a 6.0 Ford as we speak like it's a wiper blade installation but ashamed of the vinyl floor install of my F150.
-
SBeginning on the carpet. I have zero problems tearing into any engine or transmission yet for whatever reason I'm a bit nervous on this...
-
SVery nice Ed, I hope to see it driving by some day.