Shane¹'s latest activity
-
SAwesome! Did you use any of the parts that I sent you for it?
-
SShane¹ replied to the thread What's on your bench?.Just got this one off the bench. Hopefully test it out soon see how it compares against a 346xp
-
-
SFinished the 026 wrap up this morning.
-
SThat is most outstanding!
-
SDid you just cut and weld that last section? Came out amazing.
-
SThat was where I had to actually buy some tubing. I moved the plastic bracket/mount up the tube as far as I could then cut down the rest...
-
SSorry, I am not Mark, but this is what I use. I started with the small tubes, but used them up real quick, now I have moved onto the...
-
SShane¹ replied to the thread Fixing hole in tank.I would try the tank weld first it is like a putty like playdough and you can form it into the hole. And it dries in like 10 minutes. I...
-
SSo… which one? @heimannm
-
SJonsereds 920.
-
SDefinitely in for a set eventually 😀
-
Spop rivet and redkote?
-
SDrill and tap. 1/8” pipe plug should work as long as it’s thick enough. Install with red locktite or maybe epoxy. I remember @Stump Shot...
-
SIt will work as long as the area involved has a little bit of "meat" to it to make a couple few threads. Being a tank and not a...
-
SLooks complete I have sets of dawgs for these if you need them. Details in the 2100 thread…
