Shane¹'s latest activity
-
SShane¹ replied to the thread Husqvarna 350 build thread.What about doing machine work on the 350 cylinder? Do you think it is worth the extra work or not?
-
SProbably another 20% if using a 44.3mm top end.
-
SShane¹ replied to the thread Husqvarna 350 build thread.@farminkarman how much do you think full machine work and port work would gain over the mild porting you plan to do on this one?
-
SI have not had any of those come loose. (4 of em) By this I mean I have not had a 357-359 come loose without the support.
-
SYes, I recommend this approach on those too.
-
SCan this be used on 357 359 ? part number is 588775502
-
SThanks for the add on the different thread types. Any of the AM risers I have gotten are based off the latest design with the M5...
-
SGreat thread. I know of at least three bearing cups. The oldest had coursed threads on the cylinder and the crankcase screws. Then came...
-
SOne of my favorite 350 mods using a part that I stole from a 353 and mounted on a 350 with muff mounts that kept loosening up. I cut off...
-
SYep, I do that too!
-
SAgree. A set of name brand bearings is dirt cheap.
-
SShane¹ replied to the thread Husqvarna 350 build thread.I personally would want to use a good new bearing with an aftermarket seal over a crunchy old oem bearing out of a part saw. If the...
-
SGood callout on the AM parts thing and the slip fit of the bearings on the crank.
-
SIf it was mentioned I missed it. Does a 351 case fit into this equation?
-
S351 is basically a 353 with a 44mm top end. Open transfers. Magnesium case. If we're bringing up Jonsered, it would be a 2149
