Shane¹'s latest activity
-
SDid you by any chance, take pics of what you did on the transfer dividers? I've got a couple 353 cylinders id like to experiment with.
-
SI happened to compare a 350 to a 353-cylinder one time and what I noticed most was the upper transfers were much smaller in the 350...
-
SI can take a pic of that. I noticed it helped when doing 350/346 builds. Not sure if it is really needed with the 350 cylinder.
-
SThat is the approach I’m going to take. No machine work on this one, but I’m doing to work the transfers a bit and widen the exhaust...
-
SI just finished up a 350 and have another torn down I need to get put back together but not sure what cylinder yet. If I can get rid of...
-
SI’m reusing the OEM seals and bearings. I have yet to need to replace any on the 10+ 345’s/350’s that I have done.
-
SShane¹ replied to the thread What's on your bench?.@farminkarman are you reusing the old bearings and seals or new? I have been finding the aftermarket seals are shaped a little different...
-
SExcellent! I've got a 345, a Chinese 350 riser, and a 353 top end that id like to stick together in my abundant free time. Did you do...
-
SShane¹ replied to the thread What's on your bench?.I agree I find myself just tearing it down then go oh that parts done lol
-
SI know its a lot of effort. I have a hard time even doing teardown pictures: do work, wash hands, find phone, take pictures. So please...
-
SShane¹ replied to the thread What's on your bench?.I second this I would like to see the @farminkarman build thread
-
SI haven’t done anything with the cylinder yet. I can’t remember if there is a good 350 build thread…perhaps I need to make one?
-
SI have one to reassemble so, yea, do a thread 😃I do have oe 346 tops but they are worth more than the saw, lol
-
SI support this. Had the itch to build a 350 for awhile.
-
S@Onan18 has a bunch of threads on the 345/346/350/353 series, but i think you might be able to improve the state of the art. I'll go...
