Shane¹'s latest activity
-
SYes, the repair kit comes with two set screws. Since I never rebuilt any of my saws pumps I have no idea what the difference is. With...
-
SI have a parts saw Dan. I'll get Bubba to pull the muffler and check it out.
-
SLooking for a Dolmar piston for a 5105. Looking for OEM. Have parts, chains, cash... Let me know if you got one. Thanks, Dan
-
SShane¹ replied to the thread Dolmar PS-7300 oiling rate.If the saw oils fine sometimes but not others I would go back to what everyone else said and make sure the wings aren't worn down on the...
-
SShane¹ replied to the thread Dolmar 5100.If you take the clutch off there is just one bolt holding the whole pump in
-
SShane¹ reacted to Bill G's post in the thread WANTED Husqvarna 2100 brake handle, air filter cover with
Like.
I will put it back on the shelf then. -
SShane¹ replied to the thread WANTED Husqvarna 2100 brake handle, air filter cover.I ordered a handle from a 480 if it doesn't work I may take you up on that offer
-
SShane¹ reacted to Bill G's post in the thread WANTED Husqvarna 2100 brake handle, air filter cover with Like.
I will gladly post up any pics and measurements you need.
-
SSits better in the front now. Need to haul it to work, get my pinion angle squared away and do the alignment.
-
SShane¹ replied to the thread What's on your bench?.I like the cat ones better than the SLR mufflers because you can get the stock outlet bigger and you have to open them up either way
-
SThose are fun
-
SI've been battling with the front springs on my car. Due to the location of the tubular lower arm pockets it has made getting the longer...
-
SShane¹ reacted to ErnieG's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
It does show the routing but doesn't define which line goes where on the carb? The problem i have is i bought the saw without the carb...
