Shane¹'s latest activity
-
SShane¹ reacted to Jrmy_1's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
Where do you buy them from in Europe? Looking for one to put on my 6421 and everything I'm finding is $200 ish. -
SIt just so happens to be AWD, but I am willing to put in the effort to remove the front driveshaft to make burnouts possible.
-
SShane¹ replied to the thread Cheap Carbs for Weed Whacker.I have had a similar experience to these other guys 2 bad but probably 8-10 work fine. I prefer Amazon because when they don't work they...
-
SShane¹ reacted to Stoa25's post in the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek with Like.
I just got back from visiting my elderly father. While I was there he asked me to help him with his lawn mower. It was “hanging up”...
-
SShane¹ reacted to farminkarman's post in the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek with Like.
I would assume it has compression release unless you find otherwise.
-
SShane¹ reacted to EFSM's post in the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek with Like.
Yes, this does have ACR. To my knowledge, the only B&S that don't are the big block Vanguards. I've never seen one fail though; they are...
-
SShane¹ reacted to Stoa25's post in the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek with Like.
Thank you for your insight. Now that I know it most likely has the ACR I will look for the bump the next time I visit him.
-
SShane¹ reacted to redline4's post in the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek with Like.
Don't forget the starter, poor ground or crappy little battery cables they use either. Once upon a time I raced mowers and we had some...
-
SShane¹ replied to the thread HELP! Cam Shaft in. Briggs & Stratton 24hp V-twin Intek.Are you sure the valves are adjusted right? Not questioning you but just asking because I would recheck them 1 more time. I have set...
-
SShane¹ replied to the thread WANTED 2101 tank/handle.Sorry @Jake Dykstra for the high jack of your thread. I don't need a 3 pawl starter that bad I got my 2 pawl setup working for now I can...
-
SI'd be doing without if I sold my one complete starter. You have any spare starter parts?
-
SI have a used 3 pawl flywheel
-
SI may be interested in that if @Jake Dykstra doesn't want it and the magnet in mine won't reattach with JB Weld or something.
-
SOk - I think I have an extra three-pawl starter if @Sloughfoot doesn't but I do not have the flywheel.
