Shane¹'s latest activity
-
S254 is all done! Before: After: Anyone have an outer felling dog for it?
-
Slol , you got it
-
SThat's what I've got, couple of factory filters and a non modded plastic too. I'd like to run the factory setup but apparently it's a...
-
Swhat do you guys use to replace the old oil lines on these bad boys. I can find the one line coming from the tank with the bulge fitting...
-
SI've been lucking out with getting them off donors. May have an extra for you.
-
Shttps://www.jackssmallengines.com/jacks-parts-lookup/part/husqvarna/501606801
-
SI was thinking I could use some similar fuel or oil line and just cut it to fit. The one I tried yesterday still leaked. Might need some...
-
SShane¹ replied to the thread Husqvarna 2100 thread.Anyone know without a lot of searching what the real differences between 298 and 2100 were?
-
SIt’s the wannabe 2100 lol , all good
-
SShane¹ reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
A german collector sent me a used ignition harvested from another DOLMAR 152. It has the same Bosch-number than the faulty one built... -
SShane¹ replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.Any 119 or 120 ignition should work too. Just make a mental note of where the flywheel key is early 119 was different than 120 and 123...
-
SShane¹ reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
I see conversion to ignition chip could be some kind of last resort but would like to avoid such botch-up (no pun intended). I...
-
SShane¹ reacted to nv656's post in the thread SELLING Parts saws husky 345 and McCulloch 610 with Like.
Selling 2 barn find condition saws for parts or builders McCulloch 610 , 20$ plus shipping. Pretty nice shape, appears to be low hour...
