Shane¹'s latest activity
-
SGot a clutch cover that wasn’t cracked from EBay and installed old pieces plus a new brake band and new OEM flag on it. I am missing...
-
SShane¹ replied to the thread Aftermarket Rancher clutch covers.Here is my 353 saw with a $13 Amazon cover
-
-
SThat the OEM will work without me having to do anything tedious. I'm open to the possibility the AM will, too. Will report either way.
-
SShane¹ replied to the thread Aftermarket Rancher clutch covers.What is the bet?
-
SThanks. I ordered one aftermarket and one OEM today to compare. I have a bet with myself. ;)
-
SShane¹ replied to the thread Grease Monkey Garage.One might be a flex fuel injector? And maybe the flow rate is different. The lt1 swap guy has quite a bit of info on injectors and psi...
-
-
SShane¹ replied to the thread Grease Monkey Garage.I think I have some good injectors if you end up needing just one or two
-
SThe part number injectors I have are rated at 60psi
-
SBased off the plugs and header temps cylinders 1, 3, and 5 are not firing. One would never know it based off sound or vibration of the...
-
SShane¹ replied to the thread Grease Monkey Garage.I know you have already been over it 1000 times and probably know more than any of us providing ideas but. Fuel pressure could still be...
-
SShane¹ reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
Same on PS-6100 & PS-6400 Current part number: 257384-9 -
SIt seems it would make bar/chain changes less of a PITA with the outboard clutch.
-
SI did. It didnt change anything, which I expected. While I had the plugs out I did a compression test, which was fine. My next plan is...
-
SShane¹ replied to the thread Aftermarket Rancher clutch covers.Yes remove the tensioner on the saw and use the one in the new clutch cover
-
SDid you remove the stock tensioner on the saw? This would be nice for the 359 as well…
