Shane¹'s latest activity
-
SThere used to be a shop out here called pacific fab that did a lot of LS. I think they went under a because of the owner and the main...
-
SIve never seen a holley LS system before, thats a bummer it wont run right. with having that style of engine control I am not familiar...
-
SShane¹ replied to the thread Grease Monkey Garage.@redline4 possible if you have a bad injector dumping fuel? If left side was that much cooler could you swap the injectors from one side...
-
SShane¹ replied to the thread Grease Monkey Garage.Man this is so frustrating do you have a stock harness and an ECU? I had lt1 swaps program an ECU for my cj and it seems to run pretty...
-
SSo after some time off on the car, I went back to it today. Here's what I noticed.. If I key it on, my AFR will bounce around probably...
-
SShane¹ replied to the thread FOUND IT Husqvarna 394 carburetor and recoil.Picked up a recoil just need an air duct and would like to find an OEM carburetor
-
SMark
-
SIf a job's worth doing, it's worth doing again!
-
SBetter 😉👍
-
SI have not investigated the Porter Cable saw very much so I am not sure who built the engine. The styling of the cylinder and fits is...
-
SThe 254 runs! Still waiting on some parts though: clutch cover, bar plate, tensioner, switch block off plate, screws, and choke lever...
-
SChain too big 😉👍
-
STime to do the 394 cases. Look at that chain rash… I’ll probably drill the end of the crack and smear some JB weld on it.
-
STwo updates: The 288xp seems to be running pretty good now. I installed a different crank, new bearings, and a Meteor piston kit...
