Shane¹'s latest activity
-
SShane¹ replied to the thread What's on your bench?.I have some miscellaneous 394 parts kicking around when you get to that one
-
SAs promised, I snagged these 254 and 394 carcasses, plus a 372 cylinder and carb, for $100 from a local saw shop. The 394 has a full...
-
SPicked this saw a while back. It was too good of a deal to pass up. But I could use the money to fund some other projects. All OEM...
-
-
SHeck, these days the clutch cover will set you back a couple hundred. Nice looking saw, GLWS!
-
SJust put a few nicer parts on this tonight ready to go to a new home. Runs oils and cuts as it should. Has a hyway piston and...
-
-
SShane¹ replied to the thread What's on your bench?.Swapped some parts around and made this saw even nicer
-
-
SShane¹ reacted to Gavinmalloy18's post in the thread FOUND IT Makita/dolmar 6400/7900 stock with
Like.
Looking for any of these saws in stock form in good running shape. Thanks -
SYou need a 390, a 395 and a 3120.
-
SWhat I actually think I need is a 254 and a 394. And I just so happen to know where two carcasses are sitting that I’m going to buy next...
-
SI have a stock dukes on a 350 I built running strong through 8 tanks or so.
-
SI think I’m becoming a Husqvarna man… 288, 345, 350, 359, 372, 55, 242, and 266 in the picture.
-
SToss it in a lake. If it's bad it will sink. If it's good it will float. Least that's what Dallas told me.
-
SShane¹ reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Piston rings, piston and cylinder are also failure prone on these due the extremely dusty conditions they worked in. The Wacker BTS-11...
-
SShane¹ reacted to mgr1's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Check the crankshaft/conrod before searching parts to convert it. Most of this bts 11 have a bosh ignition with limiter.
-
SShane¹ reacted to FederalQ's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
He would like to convert it, but the list of parts needed and availability may nix that. I am sure it would need an oil pump, clutch...
