Recent content by Sawponder

I think I do, I'll get pictures once I get home

I've got a 372xt walbro carb and 394xp walbro carb to sell both used - may or may not need a rebuild 50 each plus shipping

$1000 + shipping

Has this 50 year anniversary sticker on the top cover, has anyone ever seen one? Could this be the equivalent to husqvarna's 300th anniversary sticker?

I also have a 680 and you are correct, there is no decomp and i fear for the life of my recoil because of it!

I've got a NOS crankcase w oem bearings in orange. Identical to the red ones. $250

Very nice Solo 690 less than 10 tanks of fuel run through it When I bought this saw, I went through the entire saw, replaced the orings on both sides of crankcase along with both crank seals. Carb that came with saw from factory was bad which is probably why it had almost no run time when I got...

Ive got a mint, low hour Solo 690 that id trade for your 7900 if interested

Ive got a NOS crankcase that comes with new oem crank bearings.....just missing the crankshaft

Trying to figure out what size crank bearings are in this blower. I believe it is a 6302 with 16mm inner diameter (rather than the usual 15mm) Both blowers had tiny bit of radial play from crankshaft ends. but the bearings arent press fit they just slide onto the crankshaft, and also just...

I just unpacked my project 350 and just realized i also need a carb and pre-carb intake manifold. Whatever singinwoodwackr doesnt have ill get from you, 59billy.

I thought i had a top cover, turns out the one i have is for 357/359. Ill take a top cover if you have one

Anyone have both side covers for a 340/345/350 husqvarna?

Looking for pto side crankcase half for the ms461. May consider an entire bottom end if price is right

Yes, They are new single loop boxes