Recent content by rsmraider

I got my rotary tool I removed all casting defects and smoothed the scored area with a polishing pad. Does not seem to be lining up with where ring gap is when I check. The groove is no longer noticeable when I try and run my fingernail on it. I enlarged the exhaust and polished it but left the...

I purchased that oil with a Stihl 251 that I purchased also around the time I bought this one (to extend the warranty another year) and have not run out of it yet. I have a couple more bottles left. The family members use the same camp and they were clearing the trees while I was busy with work...

Doesn't seem to be anything wrong with the piston other than the carbon build up. I cleaned the piston with one of those old kitchen green scrubbers and WD-40. I did not use anything inside cylinder beside paper towels and WD-40. I have to admit that I was not the only one to mix the fuel this...

Hello Everyone, I purchased an Echo 590 last year in September. I use it mainly for firewood and have not been cutting often until last month; I used it to clear out a large area around our camp. I have been running it a little bit rich since after I received it. I had to take it apart and...