Ronie's latest activity
-
Ronie reacted to Maintenance Chief's post in the thread Any Chinese chainsaw and chinese parts discussion with
Like.
I've used a bunch of Joe's also, rivet nuts is what I use most of the time. -
Ronie reacted to ammoaddict's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
Thanks, I might get a couple and try stainless steel rivet nuts.
-
Ronie reacted to Czed's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
Braze or screwed them on Anything you want to do they are tough.
-
Ronie reacted to Czed's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
No but I've used dozens of joe harkness's Red97 deflectors I just order a variety They've worked perfectly.
-
Ronie reacted to drf256's post in the thread 064 660 hybrid with first fingerbanging attempt. with Like.
The smaller the bore, the more compression they can tolerate. Too much compression is gonna add too much heat. You’ll notice you won’t...
-
Ronie reacted to drf256's post in the thread 064 660 hybrid with first fingerbanging attempt. with Like.
Idk about your numbers and overall setup with that cylinder. The 1122 are limited by the narrow piston skirt, so they tend to need...
-
Ronie reacted to Canadian farm boy's post in the thread 064 660 hybrid with first fingerbanging attempt. with Like.
You’ve lowered that cylinder a mile. How’s the ROD(ring of death) to piston ring looking? You’re upper transfers will be huge raising...
-
Ronie reacted to NorcalFlyingsquirrel's post in the thread 064 660 hybrid with first fingerbanging attempt. with Like.
Cut alot out of squish and base .06 or something, little freeport but my 44 hyb does amd it rips. ended up at 105 135 to 144 trans and...
-
Ronie replied to the thread Any Chinese chainsaw and chinese parts discussion.I've seen that a couple of times.
-
Ronie reacted to Maintenance Chief's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
I did put a step in my exhaust port Ron. I saw an old post where MM did that to a 372xp he ported.
-
Ronie replied to the thread Any Chinese chainsaw and chinese parts discussion.I worked on the Farmmac today and got a big bore ported for it.
-
-
201 in for repairs and a mostly complete 281, cleaning time...
-
Tried out my new cheap Ali Express Powder coating kit (...
-
Another FoggySail ignition repair on this Dolmar 123. You’ll notice the kill wire has been clipped and covered with epoxy, and used for...
-
I rebuilt and used the 228 carb from the 281 carcass to get the 288xp going. Sounds like a beast 😁. Do these carb have a governor? Sure...
