redneckhillbilly's latest activity
-
redneckhillbilly replied to the thread Builder’s favorite build?.it seems the autotune saws will hold a higher rpm in the cut if you let it hit the limiter than proceed to bury the bar, its hard to... -
I'm not sure on that... @srcarr52 would probably know
-
Yes, mainly the coil but the autotune seems to start to add fuel right around the rpm limit.
-
redneckhillbilly replied to the thread Builder’s favorite build?.i was just curious, probably cannot interchange them due to the autotune stuff the 592 has, yesterday I ran my cousins 585 right next to...
-
redneckhillbilly replied to the thread Builder’s favorite build?.so its mainly the coil limiting it, I can see that, if higher RPM's are not possible you can probably only do soo much, are the 585...
-
I'm not sure there would be much to gain in doing that. If you could get an unlimited coil to work with an adjustable carb, then you...
-
redneckhillbilly replied to the thread Builder’s favorite build?.has anyone sucessfully converted a 592 to carb with 585 parts? does the autotune carb on a 592 not flow sufficient air, and that...
-
redneckhillbilly reacted to farminkarman's post in the thread What oil is best? and what ratio? with
Like.
Are you sniffing lawn mowers now too? -
My wife can take one look at a box and say, "Another cylinder, eh?"
-
Had to take advantage of the season. This is the one time of year when my wife doesn't question packages arriving at the door.
-
Sailed! Going to South Carolina!
-
Maybe he had caller ID ?
-
redneckhillbilly replied to the thread Need a little guidance.any chance your fuel can is contaminated? go cut with it, you can only tune them so much without actually using them to cut.
-
If the saw will tune for it and it’s not building carbon, there are no drawbacks. In fact if he knew much about strato technology, he’d...
-
redneckhillbilly replied to the thread What octane is best, and why.Thanks for posting that, I have been searching to find a picture of that, one of the employees at a local shop is hell bent on...