redneckhillbilly's latest activity
-
NP271 maybe. Lower low than 205, depends on your usage. -
redneckhillbilly reacted to Yellowking86's post in the thread Milling with my new 3120xp and a 62” bar with
Like.
Running .404, it went through the beechwood like butter and left a smooth finish. The maple was very tough and full of knots took... -
redneckhillbilly replied to the thread Milling with my new 3120xp and a 62” bar.whats you thoughts? you running 3/8s or .404?
-
redneckhillbilly reacted to Yellowking86's post in the thread Milling with my new 3120xp and a 62” bar with Like.
Some maple and beechwood
-
Upgrade to a 205 possible? Have an NP205 with pto in my M1031 CUCV. Same thing as yer k30.
-
redneckhillbilly replied to the thread Modified 4x4s/crawlers.I would like to, I didnt want to run a cable to electro speed sensor adapter thingy when I put it together, so i searched high and dry...
-
Nice fkn wood truck! Front truetrac is the best. Hard to steer in the woods with thousands of lbs of green wood in the bed when using a...
-
redneckhillbilly replied to the thread Modified 4x4s/crawlers.theres been a few times for me when a true 4 wheel drive is what ive needed, the tru trac is soo well behaved on the snowy roads you...
-
redneckhillbilly reacted to Stump Shot's post in the thread Not so pros 4 new and without politics with Like.
Montana is a very beautiful state.
-
redneckhillbilly reacted to Stump Shot's post in the thread Not so pros 4 new and without politics with Like.
Good morning bridge fans. I can still recall going over the Moyie River Canyon Bridge in Idaho at a stellar 30 MPH with no traffic...
-
Is that a 3120 cylinder?? 😂😂😂
-
redneckhillbilly reacted to beaglebriar's post in the thread Not so pros 4 new and without politics with Like.
https://www.ebay.com/itm/135216753966?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=qdn0r8sespi&sssrc=4429486&ssuid=a2Ke8TRTTOC&var=&wid...
-
redneckhillbilly reacted to beaglebriar's post in the thread Not so pros 4 new and without politics with Like.
Howdy. Boiling a little sap…Found this scabbard on ebay. I think I’m gonna like it
-
HAHA! It's made for work. Here it is with forty 80# bags of concrete in the bed.
-
redneckhillbilly reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Ok, some tweaking of the carb and it runs! (and honestly, I think pretty good) but the temp is dropping and it's super windy in just a...