president's latest activity
-
PI’ll play
-
Ppresident reacted to Definitive Dave's post in the thread Walk over to your toolbox right now… with
Like.
Open up the fourth drawer from the top and share a picture. I actually cleaned out this drawer this morning so I cheated 😀, I figure if... -
P2 in plastic wrappers and a couple loose covers. Anyone needs one, let me know
-
PGood to hear, I just got a 100ft roll. I can’t wait to test it out!
-
PI've used up 100s of feet of it, it's my favorite chain.
-
PI prefer to restore the depth gauges to factory profile, to minimize the risk of a sharp corner catching. Use a flat file, Dremel, or...
-
PLike many others, I made one from a scrench... ...then I bought a "modern" McCulloch saw for the display and one of those was...
-
Ppresident replied to the thread HUSQVARNA HUSQVARNA THREAD.nothing like the simplicity of a 2 series husky
-
PWhat’s the shortlist of easiest older husky’s to work on. I am looking for my next project and have never used a Husqvarna or worked on...
-
PI did write "I dislike ..." , does not mean I don't! ;) I often bring them along to run a tank full of fuel through them. But also to...
-
PEcho style vents are a good replacement, just find a spot for it to hang out at. https://www.hlsproparts.com/product-p/a356000031.htm...
-
P#9 is a grub screw, I have a 046 and an 066 that are using that type of vent. Just regular fuel hose and the grub screws. I am using two...
-
PYou have to be careful when you switch from the old style boot to the newer boot- the opening in the early 064 air box is slightly...
-
PFix it now or it will bite you later.
-
PI've edited my reply, so as to not come across so blunt. My apoiges ;) Most saws respond to a little timing advance, test cut a cookie...