Powerstroke Cowboy's latest activity
-
😮 -
Since I already ordered the LRB piston for the 451E I got started on getting this 451EV cleaned so I can prepare it for the display as...
-
While rummaging around in my garage today I was reminded of another small Jonsereds up on the shelves, turned out to be another 451. An...
-
-
Powerstroke Cowboy replied to the thread So what did you buy today.I updated the post with what they are. Squish band cutters from Joe.
-
Got the saws off the shelf and tuned. Headed to Kerrville, TX, to help search for bodies.
-
-
One longer project is finished, actually started 6-7 years ago when cylinders were very cheap. It will be ported when I have worn out...
-
Powerstroke Cowboy replied to the thread So what did you buy today.Didn't buy them today. But, they just showed up. Squish band cutters from @Red97
-
-
I just needed a simple non radial arm saw so I ordered this. https://www.amazon.com/Metabo-HPT-C10FCGS-Compound-15-Amp/dp/B07PX44JQM
-
These old clunkers showed up a few days ago.
-
Nice! Yep I've used right stuff almost exclusively since 2012 on all sortsa "stuff". It also has a crazy below zero rating. Something...
-
Working purdy good. Though definitely at the limitation of the brakes going down a steep hill. Used 4 low and didn't smell any burning...
-
Well no computer bs here today. Just 22" Yukon wheels, 3/8 wheel spacers and longer studs. I will say that a 5/8 ground rod driver in...
-
On to the next project, 451E. Does anyone have, or know where I might find a piston (PN 504 41 00 04)? I think the cylinder...
