Poleman's latest activity
-
Poleman replied to the thread HELP! Husqvarna 50 Series Saw Filter Cleaning.Gasoline, brake clean or soap and water.. -
Hmmmm, no eggs yet ... :thinking:
-
For one thing - your metering lever looks way too high.
-
My diagnosis—that screw is screwed.
-
Why sell the snap on screwdrivers? Great set
-
I'm thinking $50 plus shipping on what's in each photo. The drill, batteries, and charger all work. Snap on screwdriver set is pending...
-
Poleman replied to the thread Stale fuel issues.Like said previously, two day old fuel is not stale …. You've got a saw/carb/ fuel system issue. If the other saw run fine on it and...
-
Years ago (mid 1990's) I had an 026 that was having issues at idle - a local long-time small engine tech told me to notch the throttle...
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
Poleman replied to the thread Carburetor talk - fuel puddling.What I’ve found that helps me is on the line of what Stump Shot said. Throttle closed restricting air through carb slowing mix down and...
-
Perhaps you'd only need the tensioner screw/nuts? In...
-
Poleman replied to the thread HELP! 357xp Metering Needle/Flooding Issues.Leaking Welch plug, bad Nozzle
-
Poleman reacted to ray benson's post in the thread Husky 562xp 2017 model all manuals I can get please lol with
Like.
Check your inbox.