Philbert's latest activity
-
PAnd/or pi$$ed away!
-
PThe stone that came on my WEN is out of round, not enough for me to consider taking it down to my shop and tossing it on the lathe...
-
PHave you got a pulley that fits the shaft? Put it on and check run-out on the pulley. Otherwise you could turn something on a lathe...
-
PI've had a Wen 4270 for over 5 years and its been great. I sharpen knives and scissors, and only occasional use. So I don't know how it...
-
PNot sure of the tormac but my Wen is a friction drive, so when not in use make sure to back the friction pressure off to zero to avoid...
-
PYes. This was several months ago................ The update is I now have (4):)
-
PAngle grinder on sale at Lowe's for $39.99. They were $79.99 at Tractor supply.
-
PThe pressure gauges are Dial Test Indicators for checking small measurements or run-out of shafts, or things being turned on a lathe...
-
PSome of the used taps have been abused, for want of a tap wrench. If they are not worn out I will remove the locknuts and use the taps...
-
PI bought some oily bits of metal for £250 / $330. I think that there is more than £1,000 / $1,330 value in just the brand new HSS...
-
PB&D also had such patents with a side horizontal handle in this place, I even have one
-
PJust got in for the night, went out to see Crestin's cabin afterwards and did a rudimentary policing of the grounds and shop. Food...
-
PPhilbert replied to the thread So what did you buy today.That threaded hole is for an optional, helper handle. Pretty sure I have an extra one of those, but not really needed on a smaller...
